Kia Sportage: Blower

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Heating,Ventilation, Air Conditioning / Blower

Mode Control Actuator: Repair procedures

Inspection 1. Ignition "OFF� 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the term ...

Blower Unit: Components and Components Location

Component Location Components 1. Intake case (LH)2. Intake case (RH)3. Blower motor4. Intake door5. Intake actuator6. Mofet [Auto type]7. Resistor [Manual type]8. Climate control air filter cove ...

Other Information:

Output Speed Sensor: Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. (R ...

Ultrasonic Sensor: Repair procedures
Removal 1. Lift up the vehicle. (Refer to GI group - "Lift and support points") 2. Remove the rear bumper. (Refer to the BD group - "Rear bumper") 3. Pull out the sensor by opening the s ...