Kia Optima Manuals

Kia Sportage: Shift Lever: Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sportage SL Service & Repair ManualKia Sportage: Shift Lever: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Lever: Repair procedures

Removal
1.
Remove the center console assembly.
(Refer to "Interior(console)" in BD group.)
2.
Disconnect sports mode connector (A).
3.
Remove the shift lever assembly (D).
(1)
Take off the clip (A) and then remove the shift cable (B).
(2)
Remove the bolts (C-4ea).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Installation
   
When installing, set room side shift lever and T/M side lever to "N" position.
1.
Install in the reverse order of removal.
Shift Lever: Components and Components Location
Components 1. Shift lever knob & boots assembly2. Shift lever assembly3. Shift cable assembly4. Cable retainer5. Shift cable retainer ...

Shift Cable: Components and Components Location
Components 1. Shift lever knob & boots assembly2. Shift lever assembly 3. Shift cable assembly4. Cable retainer ...

Other Information:

Heating
1.Set the mode to the position. 2.Set the air intake control to the outside (fresh) air position. 3.Set the temperature control to the desired position. 4.Set the fan speed control to the desired ...

Blower Resistor: Repair procedures
Inspection 1. Measure terminal-to-terminal resistance of the blower resistor. 2. measured resistance is not within specification, the blower resistor must be replaced. (After removing the resi ...

Categories


Copyright © www.kispmanual.com 2014-2024