Kia Sportage: Battery replacement - Remote keyless entry - Features of your vehicle - Kia Sportage SL Owners ManualKia Sportage: Battery replacement

Third generation SL (2010–2016) / Kia Sportage SL Owners Manual / Features of your vehicle / Remote keyless entry / Battery replacement

A transmitter uses a 3 volt lithium battery which will normally last for several years. When replacement is necessary, use the following procedure.

1.Insert a slim tool into the slot and gently pry open the transmitter center cover.
2.Replace the battery with a new battery (CR2032). When replacing the battery, make sure the battery position is positioned battery.
3.Install the battery in the reverse order of removal.

For transmitter replacement, see an authorized Kia dealer to reprogram the transmitter.

✽ NOTICE

An inappropriately disposed battery can be harmful to the environment and human health.

Dispose the battery according to your local laws or regulations.

IC WARNING

This device complies with Industry Canada licenceexempt RSS standard(s).

Operation is subject to the following two conditions : (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Transmitter precautions
The transmitter will not work if any of the following occurs: The ignition key is in the ignition switch. You exceed the operating distance limit (10 m [about 30 feet]). The battery in the tra ...

Smart key
With a smart key, you can lock or unlock a door (and tailgate) and even start the engine without inserting the key. The functions of the buttons on a smart key are similar to the remote keyless ...

Other Information:

Tilting the sunroof
Before opening or closing the sunroof, open the roller blind (refer to the following page for instructions on how to use the roller blind). To open the sunroof, push the sunroof control lever upw ...

Balance Shaft & Oil Pump: Repair procedures
Removal BSM (Balance Shaft Module) Chain System 1. Remove the timing chain. (Refer to Timing System in this group) 2. Install a stopper pin (A) after compressing the balance shaft chain tens ...

Categories


Copyright © www.kispmanual.com 2014-2024