Description |
1. |
Heater unit includes mode control actuator and temperature control actuator. |
2. |
Temperature control actuator is located at the heater unit.
It regulates the temperature by the procedure as follows. Signal from
control unit adjusts position of temperature door by operating
temperature switch and then temperature will be regulated by the
hot/cold air ratio decided by position of temperature door |
Radiator: Repair procedures
Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester.
2.
Apply a pressure of 93.16 ~ 122.58kPa (0.95 ~ 1.25kg ...
Windshield Wiper-Washer Switch: Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after removing 3 screws.
Take care not to damag ...