Specifications |
Control pressure kpa (kgf/cm?, psi) | 490.33(5.0, 71.12) |
Internal resistance(?) | 10 ~ 11 |
Repair procedures
Inspection
1.
Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column.
2.
Check for continuity between the terminals.
3.
If continu ...
Accelerator Position Sensor (APS): Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Specification: Refer t ...