Kia Optima Manuals

Kia Sportage: Fender: Repair procedures - Exterior - Body (Interior and Exterior) - Kia Sportage SL Service & Repair ManualKia Sportage: Fender: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body (Interior and Exterior) / Exterior / Fender: Repair procedures

Replacement
   
•
When removing and installing the fender, an assistant is necessary.
•
Be careful not to damage the fender and body.
•
When removing the clips, use a clip remover.
1.
Remove the front bumper cover.
(Refer to the BD group – “Front bumper”)
2.
Loosen the mud guard (A) mounting screws and clips.

3.
After loosening the mounting screws and clips, then remove the side sill moulding (A).

4.
Detach the clips and then remove the insulator pad (A).

5.
After loosening the mounting screw and bolt, then remove the front bumper side mounting bracket (A).

6.
After loosening the mounting bolts, then remove the fender (A).

7.
Installation is the reverse of removal.
Exterior
...

Hood: Repair procedures
Replacement Hood Assembly Replacement     • When removing and installing the hood, an assistant is necessary. • Take care not to damaged the hood an ...

Other Information:

Heated Oxygen Sensor (HO2S): Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 4 and 5 [B1/S1]. 4. Measure resistance between the HO2S t ...

Electric Waste Gate Actuator (EWGA): Troubleshooting
Signal Waveform ...

Categories

Copyright www.kispmanual.com 2014-2026