Never remove the radiator cap when the engine is hot. Serious
scalding could be caused by hot fluid under high pressure escaping from
the radiator.
When pouring engine coolant, be sure to shut the relay box
lid and not to let coolant spill on the electrical parts or the paint.
If any coolant spills, rinse it off immediately.
1.
Make sure the engine and radiator are cool to the touch.
2.
Remove radiator cap (A).
3.
Loosen the drain plug (A), and drain the coolant.
4.
Tighten the radiator drain plug securely.
5.
After draining engine coolant in the reservoir tank, clean the tank.
6.
Fill the radiator with water through the radiator cap and tighten the cap.
To most effectively bleed the air, pour the water slowly and press on the upper/lower radiator hoses.
7.
Start the engine and allow to come to normal operating
temperature. Wait for the cooling fans to turn on several times.
Accelerate the engine to aid in purging trapped air. Shut engine off.
8.
Wait until the engine is cool.
9.
Repeat steps 1 to 8 until the drained water runs clear.
10.
Fill fluid mixture with coolant and water (55~60%) (except
for North America, Europe and China : 45~50%) slowly through the
radiator cap. Push the upper/lower hoses of the radiator so as bleed air
easily.
•
Use only genuine antifreeze/coolant.
•
For best corrosion protection, the coolant concentration must
be maintained year-round at 55% (except for North America, Europe and
China : 45%) minimum.
Coolant concentrations less than 55% (except for North
America, Europe and China : 45%) may not provide sufficient protection
against corrosion or freezing.
•
Coolant concentrations greater then 60% will impair cooling efficiency and are not recommended.
•
Do not mix different brands of antifreeze/coolants.
•
Do not use additional rust inhibitors or antirust products; they may not be compatible with the coolant.
11.
Start the engine and run until coolant circulates.
When the cooling fan operates and coolant circulates, refill coolant through the radiator cap.
12.
Repeat 11 until the cooling fan 3 ~ 5 times and bleed air sufficiently out of the cooling system.
13.
Install the radiator cap and fill the reservoir tank to the "MAX" (or "F") line with coolant.
14.
Run the vehicle under idle until the cooling fan operates 2 ~ 3 times.
15.
Stop the engine and wait coolant gets cool.
16.
Repeat 10 to 15 until the coolant level doesn''t fall any more, bleed air out of the cooling system.
It takes time to bleed out all the air in the cooling system.
Refill coolant when coolant gets cool completely, when recheck the
coolant level in the reservoir tank for 2~3 days after replacing
coolant.
Engine Overheat Troubleshooting
Inspection RemedyVisual inspectionInspect for shortage of coolant in reservoir tank .Reinspect after replenishing coolant.Inspect for coolant pollution after remo ...
Anti-lock brake system (ABS)
ABS (or ESC) will not prevent accidents due to improper or dangerous driving
maneuvers. Even though vehicle control is improved during emergency braking, always
maintain a safe distance between yo ...
Power Door Lock Switch: Repair procedures
Inspection
Driver Power Door Lock Switch
1.
Disconnect the negative battery terminal.
2.
Remove the front door trim.
(Refer to the BD group - "Front door")
3.
Disconnect the switch conne ...
Kia Sportage: Coolant: Repair procedures
Troubleshooting
Radiator: Components and Components Location