Kia Sportage: Ignition Switch Assembly

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Ignition Switch Assembly

Fob Holder: Repair procedures

Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the floor console. (Refer to the BD group - "Console") 3. Disconnect the connector (B), then remove the fob holder assemb ...

Repair procedures

Inspection 1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. 2. Check for continuity between the terminals. 3. If continu ...

Other Information:

Water pump: Troubleshooting
Troubleshooting Water Pump SymptomsPossible CausesRemedyCoolant leakage • From the bleed hole of the water pump Visually check • Check leaks after about ten-minute warming u ...

Non-operational conditions of Back up warning system
The Back up warning system may not operate properly when: 1.Moisture is frozen to the sensor. (It will operate normally when the moisture has been cleared.) 2.The sensor is covered with foreign ma ...