Kia Sportage: Fob Holder: Repair procedures - Button Engine Start System - Body Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: Fob Holder: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Button Engine Start System / Fob Holder: Repair procedures

Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the floor console.
(Refer to the BD group - "Console")
3.
Disconnect the connector (B), then remove the fob holder assembly (A) after releasing the hook (C).

Installation
1.
Install the fob holder assembly.
2.
Install the floor console.
3.
Install the negative(-) battery terminal.
Fob Holder: Components and Components Location
Component ...

Ignition Switch Assembly
...

Other Information:

Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perf ...

Rear Cross Member: Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bo ...

Categories


Copyright © www.kispmanual.com 2014-2025