Kia Sportage: 4WD ECU: Repair procedures

Third generation SL (2010â€“2016) / Kia Sportage SL Service & Repair Manual / 4 Wheel Drive (4WD) System / 4WD Control System / 4WD ECU: Repair procedures

Replacement

Prior to replacing the 4WD ECU, check the 4WD ECU''s clutch learing with the GDS tool. (Refer to " Coupling assembly " in 4WD group)

1.	Remove the lower panel. (Refer to "Crash Pad" in BD group)

2.	Remove the IPM.(Refer to "Fuses and Relays" in BE group)

3.	Remove the parking brake pedal.(Refer to "Parking Brake System" in BR group)

Remove the 4WD ECU(C) after removing the nut (A-2ea) and the connector (B).

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation is the reverse of removal.

Prior to installing a new ECU, upload the original ECUâ€™s clutch learing to the replacement ECU using the GDS tool. (Refer to " Coupling assembly " in 4WD group)

4WD ECU: Components and Components Location

Component Location 1. Crash pad2. Crash lower panel3. 4WD ECU ...

Coupling Assembly

...

Other Information:

Jump starting
Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehicle or battery, follow these jump starting procedures. If in doubt, we strongly recom ...

DBC Switch: Repair procedures
Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad side switch assembly. 3. Check the continuity between the switch terminals as ...

Kia Sportage: 4WD ECU: Repair procedures

4WD ECU: Components and Components Location

Coupling Assembly

Other Information:

Categories