Kia Sportage: When connecting a Bluetooth® Phone
- Before connecting the head unit with the mobile phone, check to see that
the mobile phone supports Bluetooth® features.
- Even if the phone supports Bluetooth®, the phone will not be found during
device searches if the phone has been set to hidden state or the Bluetooth®
power is turned off. Disable the hidden state or turn on the Bluetooth® power
prior to searching/connecting with the Head unit.
- Bluetooth phone is automatically connected when the ignition on.
- If you do not want automatic connection with your Bluetooth® device, turn
off the Bluetooth® feature within your mobile phone.
- The Handsfree call volume and quality may differ depending on the mobile
phone
- Park the vehicle when connecting the head unit with the mobile phone.
- Bluetooth® connection may become intermittently disconnected in some mobile
phones. Follow these steps to try again.
1. Within the mobile phone, turn the Bluetooth® function off/on and try again.
2. Turn the mobile phone power Off/On and try again.
3. Completely remove the mobile phone battery, reboot, and then again.
4. Reboot the audio system and try again.
5. Delete all paired devices, pair and try again.
- Handsfree call quality and volume may differ depending on the model of your
mobile phone.
Bluetooth® Handsfree is a feature that enables drivers to practice safe
driving. Connecting the head unit with a Bluetooth® phone allows the user to
conveniently make and receive calls and us ...
When using the voice recognition feature, only commands listed within the
user's manual are supported.
Be aware that during the operation of the voice recognition system, pressing
any k ...
Other Information:
Troubleshooting
Troubleshooting
Trouble SymptomProbable causeRemedyVehicle pulls to one sideScoring of driveshaft ball jointReplaceWear, rattle or scoring of wheel bearingReplaceDefective front suspension and st ...
Injector: Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the injector connector.
3.
Measure resistance between the injector terminals 1 and 2.
4.
Check that the resistance is within t ...