Kia Optima Manuals

Kia Sportage: Rear Bumper: Repair procedures - Bumper - Body (Interior and Exterior) - Kia Sportage SL Service & Repair ManualKia Sportage: Rear Bumper: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body (Interior and Exterior) / Bumper / Rear Bumper: Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trip pieces to without marring the surface.
•
Take care not bend or scratch the cover and other parts.
1.
After loosening the mounting screws, then remove the rear combination lamp (A).
2.
Push the lock pin, disconnect the connector (B).

3.
After loosening the rear bumper side’s mounting screws and clip, then disconnect the side’s.

4.
Loosen the mounting bolts.

5.
After loosening the mounting screws and clip, then remove the rear bumper (A).

6.
Push the lock pin, disconnect the rear bumper main connector (A).

7.
Installation is the reverse of removal.
   
•
Make sure the connector is plugged in properly.
•
Replace any damage clips.
Rear Bumper: Components and Components Location
Components 1. Front bumper cover2. Front bumper side bracket [RH]3. Front bumper side bracket [LH] ...

Seat & Power Seat
...

Other Information:

Components and Components Location
Components Location 1. Sub frame2. Assist arm3. Upper arm4. Lower arm5. Trailing arm6. Rear axle7. Coil spring8. Shock absorber9. Drive shaft10. Stabilizer11. Differential carrier Components ...

Engine compartment
GDI engine T-GDI engine 1. Engine coolant reservoir 2. Engine oil filler cap 3. Brake/clutch* fluid reservoir 4. Positive battery terminal 5. Negative battery terminal 6. Fuse box 7. Air c ...

Categories

Copyright www.kispmanual.com 2014-2026