Front Body A |
Hood hinge mounting hole (O12) | Fender apron upper panel tooling hole (O8) | Front suspension mounting hole (O11) |
Side outer panel corner | Front pillar corner | Cowl panel tooling hole (O10) |
Front Body B |
Hood hinge mounting hole (O12) | Fender apron upper panel tooling hole (O8) | Engine mounting bracket hole (O12) |
Transaxle mounting hole (O16) | Engine mounting bracket hole (O14) | Transaxle mounting hole (O16) |
Front side member tooling hole (O10) | Front side member tooling hole (10X14) | Front end module mounting hole (O9) |
Front end module mounting hole (O9) |
Front Body C |
Engine mounting bracket hole (O12) | Transaxle mounting hole (O16) | Engine mounting bracket hole (O14) |
Transaxle mounting hole (O16) | Front side member tooling hole (O14) | Front side member tooling hole (14X10) |
Description and Operation
Description
The hydraulic system consists of oil, an oil filter, an oil pump, and a valve body (valves and solenoid valves).
The oil pump is powered by the engine. ATF passes through the oil filt ...
Rear Hub - Carrier: Repair procedures
Replacement
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque :
88.3 ~ 1 ...