Kia Sportage: Troubleshooting

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Suspension System / Tire Pressure Monitoring System / Troubleshooting

TPMS Inspection method

Inspection

Find the inspection number by referring to the table above.

The following content is irrelevant of the inspection procedure.

Warning lamp types

•	Keeps on without blinking : Low pressure tire warning lamp

•	Flashes at 0.5 second intervals constantly : Initial state warning lamp

•	Cluster blinks for 1 minute at 1 second intervals, then turns ON : Error code warning lamp

Turn IG OFF and then IG ON again to check the warning light type.

(1) Check the warning lamp state.

•	Check the vehicle warning lamp state.

•	Check if the warning lamp state is caused by tire low pressure. Symptom : Keeps on without blinking

(2) Check the warning lamp state.

•	Check the vehicle warning lamp state.

•	Check if the warning lamp state is caused by the initial state (virgin mode) of TPMS receiver. Symptom : Flashes at 0.5 second intervals constantly.

(3) Check the warning lamp state.

•	Check the vehicle warning lamp state.

•	Check if the warning lamp state is caused by error code (TPMS receiver & TPMS sensor failure). Symptom : Cluster blinks for 1 minute at 1 second intervals, then turns ON.

Low tire pressure warning lamp

Cold : Vehicle kept for more than 60 minutes after stopping.

> 0.07 kgf/cm? (1.0 psi) additional injection at the specified tire pressure.

Hot : Driven vehicle

> 0.28 kgf/cm? (4.0 psi) additional injection at the specified tire pressure.

In case the warning lamp fails to turn OFF after injecting tire pressure, disconnect the GDS and drive less than 1 km at 25 km/h.

Inspect initial state warning lamp

TPMS warning lamp

(1) Check the TPMS warning lamp status.

(2)Flashes at 0.5 second intervals constantly. -> Initial state warning lamp

Turn IG OFF and then IG ON again to check the warning lamp type.

Items to check in case of blinking warning lamp

(1). Enter sensor ID.

(Refer to TPMS Receiver - "Repair procedures")

(2). Enter vehicle name.

(Refer to TPMS Receiver - "Repair procedures")

(3). Enter VIN.

(Refer to TPMS Receiver - "Repair procedures")

(4). Change TPMS ECU mode (to Standard mode).

DTC checklist for performance test.

List	symptoms	Inspection items	Detailed checklist	Component/parts
C1312(FL) C1313(FR) C1314(RL) C1315(RR)	TPMS sensor receive error.	Sensor RF transmission state	Confirm sensor RF transmission Check sensor DTC Inspect Ssnsor battery	TPMS Sensor Vehicle electronic units noise Vehicle operating conditions
C1332(FL) C1333(FR) C1334(RL) C1335(RR)	Sensor internal failure	Inspect sensor RF transmission Sensor battery voltage	Check sensor RF transmission Check sensor battery (GDS)	TPMS Sensor
C1662	Auto learning failure	Sensor RF transmission state Inspect EMS vehicle speed (VS) Inspect vehicle noise	Confirm sensor RF transmission Inspect sensor battery Inspect EMS vehicle speed (VS) Inspect vehicle electronic unit noise	TPMS Sensor Vehicle electronic units noise Vehicle operating condition EMS vehicle speed signal
C1663	Auto learning failure	Sensor RF transmission state Inspect EMS vehicle speed (VS) Inspect vehicle noise	Confirm sensor RF transmission Inspect sensor battery Inspect EMS vehicle speed (VS) Inspect vehicle electronic unit noise	TPMS Sensor Vehicle electronic units noise Vehicle operating condition EMS vehicle speed signal

•	Be sure to check DTC. (Refer to DTC manual - "Tire Pressure Monitoring")

•	If the TPMS warning light does not turn on : TPMS sensor periodically learns the sensor through driving.

•	If the TPMS warning light turns on : Replace TPMS sensor, TPMS receiver.

Description and Operation

Description TREAD Lamp – Tire Under Inflation / Leak Warning. 1. Turn on condition • When tire pressure is below allowed threshold • When rapid leak is detected by the ...

TPMS Sensor: Description and Operation

Description 1. Mode (1) Normal Fixed Base State • Sensor transmissions continue at the Low Line (Base) configuration defined rates until the state is either changed by LF command or ...

Other Information:

Troubleshooting
Engine Overheat Troubleshooting Inspection RemedyVisual inspectionInspect for shortage of coolant in reservoir tank .Reinspect after replenishing coolant.Inspect for coolant pollution after remo ...

Components and Components Location
Components Location 1. Sub frame2. Assist arm3. Upper arm4. Lower arm5. Trailing arm6. Rear axle7. Coil spring8. Shock absorber9. Drive shaft10. Stabilizer11. Differential carrier Components ...

Kia Sportage: Troubleshooting

Description and Operation

TPMS Sensor: Description and Operation

Other Information:

Categories