Kia Optima Manuals

Kia Sportage: Input Speed Sensor: Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sportage SL Service & Repair ManualKia Sportage: Input Speed Sensor: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor: Repair procedures

Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the valve body assembly.
(Refer to "Valve Body" in Hydraulic System of this group)
2.
Disconnect the input & output speed sensor connector (A) from the main wiring.
3.
Remove the input & output speed sensor (B) after removing the bolts(2ea).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation
1.
Install in the reverse order of removal.
   
•
Adding Automatic Transaxle Fluid (ATF).
(Refer to "Fluid" in Hydraulic System of this group)
•
Use new valve body gasket (A).

Input Speed Sensor: Troubleshooting
Signal Waveform Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

Output Speed Sensor: Description and Operation
Description The Output Speed Sensor is a vital unit that measures the rate of rotation of the transmission''s turbine shaft and output shaft, and delivers the readings to the TCM. ...

Other Information:

Relay Box (Passenger Compartment): Repair procedures
Inspection Fuse 1. Be sure there is no play in the fuse holders, and that the fuses are held securely. 2. Are the fuse capacities for each circuit correct? 3. Are there any blown fuses? ...

Driving off-road
Drive carefully off-road because your vehicle may be damaged by rocks of roots of trees. Become familiar with the off-road conditions where you are going to drive before you begin driving. ...

Categories

Copyright www.kispmanual.com 2014-2026