Kia Sportage: Battery recharging
Your vehicle has a maintenance-free, calcium-based battery.
- If the battery becomes discharged in a short time (because, for example,
the headlights or interior lights were left on while the vehicle was not in
use), recharge it by slow charging (trickle) for 10 hours.
- If the battery gradually discharges because of high electric load while
the vehicle is being used, recharge it at 20-30A for two hours.
When recharging the battery, observe the following precautions:
- The battery must be removed from the vehicle and placed in an area with
good ventilation.
- Watch the battery during charging, and stop or reduce the charging rate
if the battery cells begin gassing (boiling) violently or if the temperature
of the electrolyte of any cell exceeds 120°F (49°C).
- Wear eye protection when checking the battery during charging.
- Disconnect the battery charger in the following order.
1. Turn off the battery charger main switch.
2. Unhook the negative clamp from the negative battery terminal.
3. Unhook the positive clamp from the positive battery terminal.
- Before performing maintenance or recharging the battery, turn off all accessories
and stop the engine.
- The negative battery cable must be removed first and installed last when
the battery is disconnected.
Keep the battery securely mounted.
Keep the battery top clean and dry.
Keep the terminals and connections clean, tight, and coated with petroleum
jelly or terminal grease.
Rinse any spille ...
Items should be reset after the battery has been discharged or the battery has
been disconnected.
Auto up/down window (See section 4)
Sunroof (See section 4)
Trip computer (See section 4)
...
Other Information:
Shift Lever: Components and Components Location
Components
1. Shift lever knob & boots assembly2. Shift lever assembly3. Shift cable assembly4. Cable retainer5. Shift cable retainer
...
Accelerator Pedal: Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the installation nuts (B), th ...