Kia Sportage: Air bag collision sensors
(1) SRS control module/ Rollover sensor
(2) Front impact sensor
(3) Side impact sensor
(4) Side impact sensor
WARNING - Air bag sensors
- Do not hit or allow any objects to impact the locations where air bags
or sensors are installed.
This may cause unexpected air bag deployment, which could result in serious
personal injury or death.
- If the installation location or angle of the sensors is altered in any
way, the air bags may deploy when they should not or they may not deploy when
they should.
Therefore, do not try to perform maintenance on or around the air bag sensors.
Have the vehicle checked and repaired by an authorized Kia dealer.
- Problems may arise if the sensor installation angles are changed due to
the deformation of the front bumper, front end module, body or front doors and/or
B pillar where side collision sensors are installed. Have the vehicle checked
and repaired by an authorized Kia dealer.
- Your vehicle has been designed to absorb impact and deploy the air bag(s)
in certain collisions. Installing bumper guards (or side step or running board)
or replacing a bumper (or front door module) with non-genuine parts may adversely
affect your vehicle’s collision and air bag deployment performance.
Curtain air bags are located along both sides of the roof rails above the front
and rear doors.
They are designed to help protect the heads of the front seat occupants and the
rear outboard s ...
Front air bags
Front air bags are designed to inflate in a frontal collision depending on the
intensity, speed or angles of impact of the front collision.
Side impact and/or curtain air bags ...
Other Information:
Important - use of compact spare tire
Your vehicle is equipped with a compact spare tire. This compact spare tire takes
up less space than a regular- size tire. This tire is smaller than a conventional
tire and is designed for tempora ...
Input Speed Sensor: Repair procedures
Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the valve body assembly.
(R ...