Components |
Connector | Pin No | Function | Connector | Pin NO | Function |
Connector(A) | 1 | High | Connector(B) | 1 | Tail Lamp (ILL+) |
2 | Middle High | 2 | Battery | ||
3 | Middle Low | 3 | Mode Actuator (VENT) | ||
4 | - | 4 | Mode Actuator (DEF) | ||
5 | GND | 5 | Temp Actuator (COOL) | ||
6 | Low | 6 | Temp Actuator (WARM) | ||
| 7 | Intake Actuator (FRE) | |||
8 | Intake Actuator (REC) | ||||
9 | - | ||||
10 | Detent | ||||
11 | Mode Actuator (F/B) | ||||
12 | Temp Actuator (F/B) | ||||
13 | Intake Actuator (F/B) | ||||
14 | Blower Motor Common (-) | ||||
15 | Blower F/B | ||||
16 | Rheostat (ILL-) | ||||
17 | IG2 | ||||
18 | IG1 | ||||
19 | Can (HIGH) | ||||
20 | Can (LOW) | ||||
21 | HTD(Rear DEF IND.) | ||||
22 | ECV IN | ||||
23 | ECV OUT | ||||
24 | - | ||||
25 | Vref (+5V) | ||||
26 | Evaporator Sensor | ||||
27 | Ambient Sensor | ||||
28 | - | ||||
29 | - | ||||
30 | - | ||||
31 | Sensor GND | ||||
32 | GND |
Mode Control Actuator: Description and Operation
Description
The mode control actuator is located at the heater unit.
It adjusts position of mode door by operating mode control
actuator based on signal of A/C control unit. Pressing mode select ...
Climate Seat: Description and Operation
Description
The system uses a FAN under the seat to help remove the moisture and warmth from occupants and surface of the seats.
It pulls in cabin air through the blower installed under the
seat ...