Kia Sportage: Immobilizer Control Unit: Repair procedures
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit: Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad") |
| 3. |
Remove the steering column assembly.
(Refer to the ST group - "steering column & shaft") |
| 4. |
Disconnect the connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening a bolt.
[USA]
[Canada]
Disconnect the connector of the SMARTRA unit(A) and then remove the bracket and immobilizer unit.
|
| Installation |
| 1. |
Install the immobilizer control unit after connecting the unit connector. |
| 2. |
Install the steering column assembly. |
| 3. |
Install the crash pad lower panel. |
Repair procedures
Replacement
Problems And Replacement Parts:
ProblemPart setScan tool required?All keys have been lostBlank key (4)YESAntenna coil unit does not workAntenna coil unitNOECM does not workPCM(ECM)YE ...
Antenna Coil: Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A).
Take care not to damage and scratch the shroud ...
Other Information:
Repair procedures
Removal
1.
Remove the tailgate trim in the trunk after removing the screws and clips.
(Refer to the BD group - "Tailgate")
2.
Remove the tailgate garnish (A) after disconnecting the connector ...
Tail Gate: Repair procedures
Replacement
Tail Gate Trim Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the relate ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright © www.kispmanual.com 2014-2025