Kia Sportage: Seat belt restraint system - Seat belts - Safety features of your vehicle - Kia Sportage SL Owners ManualKia Sportage: Seat belt restraint system

Third generation SL (2010–2016) / Kia Sportage SL Owners Manual / Safety features of your vehicle / Seat belts / Seat belt restraint system

WARNING - Shoulder belt

WARNING - Damaged seat belt

Replace the entire seat belt assembly if any part of the webbing or hardware is damaged as you can no longer be sure that a damaged seat belt will provide protection in a crash.

WARNING - Twisted seat belt

Make sure your seat belt is not twisted when worn. A twisted seat belt may not properly protect you in an accident and could even cut into your body.

Seat belts are designed to bear upon the bony structure of the body, and should be worn low across the front of the pelvis, chest and shoulders, as applicable; wearing the lap section of the belt across the abdominal area must be avoided.

Seat belts should be adjusted as firmly as possible, consistent with comfort, to provide the protection for which they have been designed.

A slack belt will greatly reduce the protection afforded to the wearer. Care should be taken to avoid contamination of the webbing with polishes, oils and chemicals, and particularly battery acid. Cleaning may safely be carried out using mild soap and water. The belt should be replaced if webbing becomes frayed, contaminated or damaged.

WARNING - Seat belt buckle

Do not allow foreign material (gum, crumbs, coins, etc.) to obstruct the seat belt buckle. This may prevent the seat belt from fastening securely.

Seat belts
...

Seat belt warning (for driver’s seat)
As a reminder to the driver, the seat belt warning light will blink for approximately 6 seconds each time you turn the ignition switch ON regardless of belt fastening. If the driver's seat be ...

Other Information:

Compression Test
Compression Pressure Inspection     If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. 1. Warm up and stop ...

Blower Resistor: Repair procedures
Inspection 1. Measure terminal-to-terminal resistance of the blower resistor. 2. measured resistance is not within specification, the blower resistor must be replaced. (After removing the resi ...

Categories


Copyright © www.kispmanual.com 2014-2024