Kia Sportage: Power Seat Motor: Repair procedures - Seat Electrical - Body Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: Power Seat Motor: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Seat Electrical / Power Seat Motor: Repair procedures

Inspection
Power Seat Motor
1.
Remove the front seat.
(Refer to BD group - "Front seat")
2.
Disconnect the connectors for each motor.

3.
With the battery connected directly to the motor terminals, check if the motors run smoothly.

4.
Reverse the connections and check that the motor turns in reverse.
5.
If there is an abnormality, replace the motors.
Components and Components Location
Component Location 1. Slide motor2. Rear height motor3. Reclining motor4. Power seat switch5. Reclining switch6. Lumbar support switch7. Lumbar support motor ...

Power Seat Control Switch: Repair procedures
Inspection 1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. Remo ...

Other Information:

Side Body: Body Repair
Side Body A Front side member tooling hole (O20)Fender apron panel tooling hole (O10)Front door upper hinge mounting hole(O13)Front door lower hinge mounting hole(O13)Fender panel mounting hole ( ...

Repair procedures
Inspection [System Inspection] 1. Disconnect the vapor hose from the intake manifold and connect a vacuum pump to the nipple on the intake manifold. · At Cold Engine [Engine Coolant Temperatur ...

Categories


Copyright © www.kispmanual.com 2014-2025