Kia Sportage: License Lamps: Repair procedures - Lighting System - Body Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: License Lamps: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Lighting System / License Lamps: Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the lens (A) and license lamp (B) after loosening 2 screws.

Installation
1.
Install the bulb.
2.
Install the license lamp lens.
Front Fog Lamps: Repair procedures
Inspection Front Fog Lamp Switch 1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mul ...

High Mounted stop lamp: Repair procedures
Removal High Mounted Stop Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the tailgate trim. (Refer to the BD group - "Tailgate") 3. Remove the spoiler. (Refer to the ...

Other Information:

Owner’s responsibility
✽ NOTICE Maintenance Service and Record Retention are the owner's responsibility. You should retain documents that show proper maintenance has been performed on your vehicle in accordan ...

Intake Air Temperature Sensor (IATS): Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between the IATS terminals 3 and 4. 4. Check that the resistance is within the speci ...

Categories


Copyright © www.kispmanual.com 2014-2025