If the engine stalls at a crossroad or crossing
If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place.
If you have a flat tire while driving
If a tire goes flat while you are driving:
1.Take your foot off the accelerator pedal and let the vehicle slow down while driving straight ahead. Do not apply the brakes immediately or attempt to pull off the road as this may cause a loss of control. When the vehicle has slowed to such a speed that it is safe to do so, brake carefully and pull off the road. Drive off the road as far as possible and park on a firm level ground. If you are on a divided highway, do not park in the median area between the two traffic lanes.
2.When the vehicle is stopped, turn on your emergency hazard flashers, set the parking brake and put the transaxle in P (Park, automatic transaxle) or reverse (manual transaxle).
3.Have all passengers get out of the vehicle. Be sure they all get out on the side of the car that is away from traffic.
4.When changing a flat tire, follow the instruction provided later in this section.
If the engine stalls while driving
1.Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place.
2.Turn on your emergency flashers.
3.Try to start the engine again. If your vehicle will not start, contact an authorized Kia dealer or seek other qualified assistance.
Disc brakes wear indicator
When your brake pads are worn and new pads are required, you will hear a high-pitched
warning sound from your front brakes or rear brakes. You may hear this sound come
and go or it may occur whene ...
Repair procedures
Inspection
1.
After disconnecting the vapor hose from the PCV valve, remove the PCV valve.
2.
Reconnect the PCV valve to the vapor hose.
3.
Run the engine at idle, then put a finger ove ...