Kia Sportage: Highway driving - Special driving conditions - Driving your vehicle - Kia Sportage SL Owners ManualKia Sportage: Highway driving

Third generation SL (2010–2016) / Kia Sportage SL Owners Manual / Driving your vehicle / Special driving conditions / Highway driving

Tires

Adjust the tire inflation pressures to specification. Low tire inflation pressures will result in overheating and possible failure of the tires.

Avoid using worn or damaged tires which may result in reduced traction or tire failure.

Never exceed the maximum tire inflation pressure shown on the tires.

WARNING - Under/over inflated tires

Always check the tires for proper inflation before driving. Underinflated or overinflated tires can cause poor handling, loss of vehicle control, and sudden tire failure leading to accidents, injuries, and even death. For proper tire pressures, refer to “Tires and wheels” in section 8.

WARNING - Tire tread

Always check the tire tread before driving your vehicle. Worn-out tires can result in loss of vehicle control.Worn-out tires should be replaced as soon as possible. For further information and tread limits, refer to "Tires and wheels" in section 7.

Fuel, engine coolant and engine oil

High speed travel consumes more fuel than urban motoring. Do not forget to check both the engine coolant and engine oil.

Drive belt

A loose or damaged drive belt may result in overheating of the engine.

Driving off-road
Drive carefully off-road because your vehicle may be damaged by rocks of roots of trees. Become familiar with the off-road conditions where you are going to drive before you begin driving. ...

Winter driving
Severe weather conditions in the winter result in greater wear and other problems. To minimize the problems of winter driving, you should follow these suggestions: ...

Other Information:

Battery: Repair procedures
Removal and Installation 1. Remove the battery. (1) Disconnect the battery negative terminal (A). Tightening torque : 4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft) (2) Disconnect the ...

Front Body: Body Repair
Front Body A Hood hinge mounting hole (O12)Fender apron upper panel tooling hole(O8)Front suspension mounting hole (O11)Side outer panel cornerFront pillar cornerCowl panel tooling hole (O10) Fr ...

Categories


Copyright © www.kispmanual.com 2014-2024