Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Lift the vehicle with a jack. |
3. |
Disconnect the canister close valve connector (A). |
4. |
Disconnect the ventilation hose (B) and vapor hose (C). |
5. |
Remove the fuel tank air filter and canister close valve assembly (A) after removing the installation nut (B). |
6. |
Release the lever (A), and then separate the canister close
valve (B) from the fuel tank air filter (C) after rotating it in the
direction of the arrow in the figure. |
7. |
Install a new fuel tank air filter in accordance with the reverse order.
|
Installation |
Fuel tank air filter bracket installation nut: 4.8 ~ 5.2 N.m (0.5 ~ 0.53 kgf.m, 3.54 ~ 3.84 lb-ft) |
Charging system warning light
This warning light indicates a malfunction of either the generator or electrical
charging system.
If the warning light illuminates while the vehicle is in motion:
1.Drive to the nearest safe loc ...
Ultrasonic Sensor: Repair procedures
Removal
1.
Lift up the vehicle.
(Refer to GI group - "Lift and support points")
2.
Remove the rear bumper.
(Refer to the BD group - "Rear bumper")
3.
Pull out the sensor by opening the s ...