Under some conditions your parking brake can freeze in the engaged position. This is most likely to happen when there is an accumulation of snow or ice around or near the rear brakes or if the brakes are wet. If there is a risk the parking brake may freeze, apply it only temporarily while you put the gear shift lever in P (Park, automatic transaxle) or in first or reverse gear (manual transaxle) and block the rear wheels so the vehicle cannot roll. Then release the parking brake.
Four Wheel Drive (4WD) transfer mode selection
When the 4WD LOCK mode is deactivated, a shock may be felt as the drive power
is delivered entirely to the front wheels. This shock is not a mechanical failure.
CAUTION - Normal road conditio ...
Rear combination lamp: Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Loose screws (2EA) holding the rear combination lamp then
disconnect the connector (A) then remove the outside rear combination
...