Inspection |
1. |
Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch.
* Diagnostic procedure refer to DTC code. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the extension cover (A). |
3. |
Remove the shower duct (A). |
4. |
Loosen the screws and then remove the cluster ionizer (A). |
5. |
Installation is the reverse order of removal. |
Front Cross Member: Repair procedures
Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage to the hub bo ...
Non-operational conditions of Back up warning system
The Back up warning system may not operate properly when:
1.Moisture is frozen to the sensor. (It will operate normally when the moisture
has been cleared.)
2.The sensor is covered with foreign ma ...