Manual type (if equipped)
To fold the outside rearview mirror, grasp the housing of the mirror and then fold it toward the rear of the vehicle.
Electric type (if equipped)
To fold the outside rearview mirror, press the button.
To unfold it, press the button again.
CAUTION - Electric type outside rearview mirror
The electric type outside rearview mirror operates even though the ignition switch is in the OFF position. However, to prevent unnecessary battery discharge, do not adjust the mirrors longer than necessary while the engine is not running. In case it is an electric type outside rearview mirror, don’t fold it by hand. It could cause motor failure.
Crankshaft Position Sensor (CKPS): Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negat ...
Heated Oxygen Sensor (HO2S): Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 4 and 5 [B1/S1].
4.
Measure resistance between the HO2S t ...